Using LaserGRBL, The movement speed of the laser engraving machine is too slow
Set a speed in LaserGRBL, but engraving occurs at slower speeds.
During processing LaserGRBL always command the speed you requested.
However, there are reasons why the engraver may move slower.
The first, and of course, is that the laser has to slow down when changing direction. The second is that the machine may be configured with a lower speed limit (keep in mind that LaserGRBL signals it to you by framing the field in red).
Both of these parameters are set in the grbl configuration, and are stored inside the control board. These are the acceleration and maximum speed parameters.
Well balanced values are usually supplied from the factory. You can try to modify them, but beware that this could lead to the machine having less accurate results.
What do you think about this post? Share your thoughts in the comments.
Comments (0)
No data
